November 30, 2021

Tankless Water Heater Flushing Kit: 12 Ultimate Tips

Tankless Water Heater Flushing Kit: The Ultimate Guide

If you have a tank water heater, then you need to know about the benefits of flushing it on occasion . First off there are many different types of hot water heaters out there but most importantly they all require maintenance and regular cleaning.

What is a Tankless Water Heater Flushing Kit?

A tankless water heater flushing kit is a lot like a flushing toilet. What you do is pour water into a tankless water heater tank, and then pump it out when you are done flushing. This saves you a lot of water, time and labor, and helps to conserve energy.

There are a couple of different types of tankless water heaters. The first is a simple tankless hot water heater, usually made by a European company. The second is an American style tankless water heater that does not require the water to be pumped out. You can also have a simple tankless heat pump water heater installed to give the hot water a consistent temperature.

Section 2: Why Flush Tankless Water Heaters on Occasion?

There are two major reasons why you should flush a tankless water heater on occasion. The first is efficiency.

Tankless Water Heater Flushing Kit | Tankless Flush Kit

 

Tankless Water Heater Flushing Kit,water heater flush kit
Tankless Water Heater Flushing Kit,water heater flush kit

Why You Need to Flush Your Tank Water Heater

There are two reasons why you need to clean out your tank water heater regularly, one is to prevent corrosion and the other is to prevent an expensive plumbing problem. Once the tank water heater loses the volume needed to flush the system, it will back-flow into the pipes and out the drains. The very same water will flow back into the tank once you back-flow valve is open. In the process you will have contaminated your water tank, sewer line and the toilet.

Flushing Your Tank Water Heater

Flushing your tank water heater helps flush out sediment and gunk. You will not be affecting your water tank’s safety, plumbing and water pressure. Flushing it also helps sanitize the tank, which is very important since you’re using it to wash clothes.

How To Buy the Right Flushing Kit

Take a look at our guide below and if you are thinking about getting a flushing kit, then you will be sure to find what you need to make sure you get the best for your tank water heater:

Quick Soak – What You Should Have At Home

8. Many tank water heaters allow you to flush the unit by turning the water on, simply wait for it to cool down then turn off the water.

Flush Valve – The Most Important Thing To Buy

How To Flush Your Tank Water Heater

We have come a long way with tank water heaters and now are able to have them integrated into our homes. A good tank water heater ensures that you have hot water when you need it and hot water when you want it, not just when the hot water taps are on.

The Best Brands of Flushing Kits

Your choices boil down to the brands that have proven quality.

1. The Baker Company

From reading other tips I’ve found that there is a battle going on for the very best tankless water heater, the best all-in-one water heater. Baker Company is a very reputable brand and comes with a good reputation.

This brand is usually regarded as one of the better brands of flushing kits and they are available for all different tankless models. You can choose between flush valves, vent valves and tank controls.

2. Elkay

Elkay has just recently launched a new brand of water heater called Elkay Passive Water Heater. They have been getting some excellent reviews on Amazon, and it seems to offer a highly affordable water heater.

How to Install Your New Flushing Kit

1. Open the tank water heater cap.

2. Turn the valve to the right.

3. While you are turning the valve, make sure that the cold water is running through the trap.

4. With the pipe removed from the cold water, you can see a blue plastic tube, that’s where the tank water flows. Remove the tube and you should see the tank water in the trap.

5. Now you can add water to your tank or go back to the cold water.

How to Flush Tank Water Heater Fluid

Some water heaters are different. When you turn on the hot water tap, it will either run into a cup or the tank. If the water is going into the tank, then it is most likely brand new. You will not want to put too much water into the tank as you do not want to empty it as you will just have to refill the tank again later.

What Do I Need To Get Started?

In order to properly dispose of any fuel/oil that may be stuck in the internal combustion portion of a water heater or even the water heater itself, there are some simple procedures to follow.

1. Open the tank cap

Get some compressed air and remove the water heater tank cap.

2. Find the drain hole

Reach inside the tank opening and check the drain hole for any signs of corrosion or sediment. If you see either then remove the tank drain cover.

3. Locate the flushing button

Once you have determined where the tank drain hole is, use a tool called a side-vent clog remover to remove the blockage. Be sure to be gentle when pulling the plug.

4. Push the plug back into the drain hole

A heavy-duty utility screwdriver is necessary to push the plastic plug back into the drain hole.

Lay Out Your Tools

Before you begin cleaning your tank water heater, you need to be ready. First of all, you need to have a pump or filter attachment for your vacuum cleaner. You need to have a small container like a bucket with warm water, a towel, a roll of paper towels and the right kind of tank cleaning nozzle for your vacuum cleaner.

Open the Tank

Find the opening in the tank, use your vacuum cleaner to suck up any water trapped inside. Don’t be alarmed if you don’t see any water dripping down as that is simply the way tank water heaters work.

Use the hose to empty the tank, wipe it clean with a towel and make sure you don’t forget to flush the tank with hot water.

Disconnect the Power

Before you begin, make sure that the plug in the tank is unplugged. The electric plug in the tank can get in the way when you are actually flushing, so make sure it is out of the way.

Prepare the Water Heater

The next step is to prepare the water heater for flushing. Depending on the size of the tank you will need to empty a large amount of water into the water heater tank to ensure that the process is properly done.

Open the Tank

Once the water heater has drained, you will need to empty the water to ensure that there is enough for your work. If you are using a gas tank, then you will need to have the tank half-filled with water, otherwise you can use a bucket to collect the water.

How To Use Your New Flushing Kit

The simplest way to do a flushing of a tank is using a needle powered water pump, there are several of these on the market today and they can be purchased easily for about $35, plus another $15 for the pumps water pump impeller. The basic pump uses a very small air pump to move the water. To start the pump, you need to place the tank full of water in the sink, and position a pressure washer over the lower flue of the tank.

Then slowly turn the washer handle until water is started to flow into the tank, then maintain the pressure on the pump to force the water into the tank, turning it as needed.

After the tank has filled with water, turn the pump off and unplug the pump to stop the flow of water.

Fill and Drain the Tank and Drain Line (Without the Pressure Washer)

The inside of your water heater is a closed loop, the outside is a wick. Which means if you don’t keep up with the water, and subsequently the tank, you can eventually have it back up. The most effective way to do this is to clean out all the debris with a pressure washer and fill with fresh water. It’s a way to scrub out some of the stuff that builds up inside the tank, the best part is that it uses much less energy than running the tank dry and refilling it. The downside is that there is a risk that some things might get away, but to save on this you can buy specially made bags and avoid this risk entirely.

Conclusion

Wrapping up the article on Tankless Water Heater Flushing Kit, we hope this guide will help you in proper maintenance of your tankless water heater. If you found this article useful, then please share it in your social circles.

Must Read : 10 Best Dream Catcher Tattoo On Thigh Ideas With Images

0 thoughts on “Tankless Water Heater Flushing Kit: 12 Ultimate Tips

Leave a Reply

Your email address will not be published. Required fields are marked *